14 Control Panels for X75 Systems Installation and Operation Manual
Chapter 2: Operation via Front Panel Controls
To set a parameter with a numeric value, follow these general steps:
1. Navigate to the required menu or submenu, and select a parameter.
2. Change to Coarse adjustment mode if required. (Fine mode is the
default mode when you first enter a parameter adjustment screen.)
As an example, you can use the control knob to either adjust a value
in increments of 0.02 (Fine mode) or 0.50 (Coarse mode).
a. Press Enter to switch to Coarse mode where you can make
large adjustments more quickly.
When in Coarse mode, the Enter button lights up.
b. Press Enter again to return to Fine mode.
3. Use the control knob to select a new value, and then press Enter to
set it.
Selected settings effect the output immediately.
4. To reset the parameter to its default value, press Default on the
front panel.
The Default LED lights up whenever the current value of the
parameter is equivalent to the default value (whether you reached
this value by pressing the Default button, or by scrolling to it with
the control knob).
5. Press Exit to accept your new value and return to the previous
menu or submenu.
To Next Page
Loading...