Harris DA-DHR6804+D - Page 50

Chapter 3
Operation
36
Copyright © 2010, Harris Corporation
Green Mode
 Enabled
 Disabled
Enables or disables the use of the
power-saving (“green”) mode
Out 1A Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 1B Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 1C Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 1D Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 2A Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 2B Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 2C Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 2D Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Ch.1 Data Rate [RO]
 Unknown
 270 Mb/s
 Bypass
 HD
 3G
Displays locked data rate for channel 1
Ch.2 Data Rate [RO]
 Unknown
 270 Mb/s
 Bypass
 HD
 3G
Displays locked data rate for channel 2
Ch. 1 Re-Clocking Mode
NOTE: Only valid with
DA-DHRO6804+ and
DA-DSR6804+D modules
 Auto
 270 Mb/s
 Bypass
 HD
 3G
Selects the reclock rate for channel 1
input
Ch. 2 Re-Clocking Mode
NOTE: Only valid with
DA-DHRO6804+ and
DA-DSR6804+D modules
 Auto
 270 Mb/s
 Bypass
 HD
 3G
Selects the reclock rate for channel 2
input
Ch1 Loss of Lock Alarm
 Disabled
 Enabled
Enables or disables Loss of Lock alarm
on channel 1 (Loss of Lock alarm
indicates the signal is not locked)
Table 3-4 DA-DHR6804+D/DA-DH6804+D/DA-DSR6804+D/DA-DS6804+D
Remotely Controlled Parameters (Continued)
Bold text = Default setting [RO] = Read only/feedback
Path Parameter Range Description