Harris NUCLEUS - Page 22

8 NUCLEUS Installation and Operation Manual
Chapter 1: Introduction and Installation
4. Align the holes on the stabilizer bracket (use the holes that have the
countersink) with the screw holes on the back of NUCLEUS-DM.
Figure 1-8. Attaching the Stabilizer Bracket to NUCLEUS-DM
5. Secure the bracket by inserting and tightening the two screws.
6. Carefully place NUCLEUS-DM into the cutout.
Figure 1-9. Mounting NUCLEUS-DM into the Cutout
Holes with
counter-sink
9.0 in.
(23.0 cm)
8.3 in.
(21.2 cm)
0.9 in.
(2.4 cm)
1.9 in.
(4.8 cm)
0.5 in.
(1.3 cm)
1.2 in.
(3.1 cm)