Introduction
Quantum
X
I3031-14.0 HBM: public 23
S Configurable Ethernet interface for data communica
tion with an operating PC
S 2 IEEE1394b FireWire interfaces
- For optional voltage supply
- For optional data communication with a PC
- For automatic time synchronization of the modules
- For real-time transfer of measurement data
between the modules
S Connector for installation on a backplane (not applic
able for ultra-robust variants)
S Status LEDs for displaying general system and chan
nel states
S A factory calibration certificate is stored on each amp
lifier, which can be read by the QuantumX Assistant.
S AutoBoot (module configurations are retained)
With amplifiers, the following applies for each
measurement channel:
S Galvanic isolation (signal inputs/outputs, voltage sup
ply, communication)
S Configurable supply voltage for active sensors
S Support for TEDS
2)
technology (read, write)
S Configurable sampling rate
S Configurable digital filter (Bessel, Butterworth)
S configurable scaling
Sensors assigned using the sensor database can be cal
ibrated via the channel and written back into the sensor
database.
2)
TEDS = Transducer Electronic Data Sheet
To Next Page
Loading...
