HBM PACEline CMD600 - Page 30

30
CMD600
A2820−1.1 en
IP_ADDRESS
Set /get IP setting for LAN. If settings are changed, new values are active after power
supply cycling or issuing command
command IP_ADDRESS DHCP_mode, IP_address, telnet_port, subnet_mask,
default_gateway
parameters:
DHCP_mode int 1.. DHCP disabled 2.. DHCP enabled(default
value)
IP_address string Format “XXX.XXX.XXX.XXX”. “192.168.1.1”
which is default value.
telnet_port int Format XXX. Default value 23.
subnet_mode string Format “XXX.XXX.XXX.XXX”. Default value
“255.255.255.0”
default_gateway string Format “XXX.XXX.XXX.XXX”. Default value
“192.168.1.0”
response OK, IP_ADDRESS = DHCP_mode, IP_address, telnet_port,
subnet_mode, default_gateway
parameters:
DHCP_mode int 1.. DHCP disabled 2.. DHCP enabled(default
value)
IP_address string If DHCP is enabled, then returned value will
be assigned IP
telnet_port int See description above.
subnet_mode string If DHCP is enabled, then returned value will
be assigned subnet mask
default_gateway string See description above.
inquiry IP_ADDRESS = ?
response OK, IP_ADDRESS = DHCP_mode, IP_address, telnet_port, subnet_mode,
default_gateway
help IP_ADDRESS?
response OK,IP_ADDRESS DHCP_mode(1..disabled,2..enabled), IP_address,
telnet_port, subnet_mode, default_gateway