HBM PACEline CMD600 - Page 29

29
CMD600
A2820−1.1 en
PROTECT_PARAM
Enable/disable protection for calibration parameters. This parameter isn’t changed when
factory default is carried out.
command PROTECT_PARAM enable
parameters:
enable int 0...parameters are not protected(all parameters
can be changed) 1...parameters are
protected(same parameters can’t be changed)
response OK, PROTECT_PARAM = enable
parameters:
enable int See description above
inquiry PROTECT_PARAM = ?
response OK, PROTECT_PARAM = enable
parameters:
enable int See description above
help PROTECT_PARAM?
response OK, PROTECT_PARAM enable