HBM PACEline CMD600 - Page 28

28
CMD600
A2820−1.1 en
MANUFACTURER_DATA
Used to inquiry data about amplifier stored during production
command not applicable
inquiry MANUFACTURER_DATA = ?
response OK, MANUFACTURER_DATA \r\n
manufacturer = manufacturer \r\n
type = device_type \r\n
firmware = hardware_revision \r\n
hardware = hardware_revision \r\n
serial = serial_number \r\n
parameters:
manufacturer string HBM
device_type string CMD600
firmware_revision string Format major.minor
hardware_revision string Format major.minor
serial_number string 7 digits number.
help MANUFACTURER_DATA?
response OK, MANUFACTURER_DATA
DEVICE_NAME
Set /get user changeable device name (max 32 characters). Used to distinguish devices
on LAN.
command DEVICE_NAME name
parameters:
name string Set name of charge amplifier. This string is
stored in amplifier EEPROM. Unit from
production has default value “New amplifier No
xxxxx”, where xxxxx is amplifier serial number
from label
response OK, DEVICE_NAME = name
parameters:
name string See description above
inquiry DEVICE_NAME = ?
response OK, DEVICE_NAME = name
help DEVICE_NAME?
response OK, DEVICE_NAME name (max 32 characters)