HBM PACEline CMD600 - Page 33

33
CMD600
A2820−1.1 en
DATA_STREAM_ENABLED
Enable real time measurement value transmiting to predefined IP address with
predefined rate.
command DATA_STREAM_ENABLED enable
parameters:
enable int 0.. Disable
1.. Enable
response OK, DATA_STREAM_ENABLED = enable
parameters:
enable int See description above
inquiry DATA_STREAM_ENABLED = ?
response OK, DATA_STREAM_ENABLED = enable
help DATA_STREAM_ENABLED?
response OK, DATA_STREAM_ENABLED enable (0.. disabled, 1.. enabled)
PAR_PACKET_COPY
Used to copy source packet of parameters to destination packet of parameters.
command PAR_PACKET_COPY source, destination
parameters:
source int Source packet of parameters[1 or 2]
destination int Destination packet of parameters[1 or 2]
response OK, PAR_PACKET_COPY
help PAR_PACKET_COPY? or =?
response OK, PAR_PACKET_COPY source_packet,destination_packet