35
CMD600
A2820−1.1 en
RESTART
Perform full reset to charge amplifier. This is same as cycling power supply. Used to
activate new network settings. Amplifier will be restarted 1 second after transmitting
response to this command.
command RESTART
response OK, RESTART
inquiry Not applicable
help RESTART?
response OK, RESTART used to restart amplifier
FACTORY_DEFAULT
This command set both packets of parameters to default values. If protection of
parameters is disabled, then all parameters set to factory default, except
ETHERNET_ADDRESS and protection parameter (PROTECT_PARAM). If protection of
parameters is enabled, then all unprotected parameters set to factory default. This
includes also IP settings. Amplifiers restore and restart will be done 1 second after
transmitting response to this command. Communication with amplifier will be probably
lost.
command FACTORY_DEFAULT
response OK, FACTORY_DEFAULT
inquiry Not applicable
help FACTORY_DEFAULT?
response OK, FACTORY_DEFAULT restore to factory default and restart
Factory default can be triggered also with SensorTeach button. See “Factory default
procedure”.
HELP
command HELP
response OK,HELP
Print all commands with comments.
To Next Page
Loading...
