HCS DAC-42A - Safety and Liability

DAC-42(A)-x-PN
Page 7
DAC-42(A)-x-PN Manual
Revision: 1.0 22.01.2024
Other identifiers (when applicable):
Identifier Description
●/ - Listings
□ References to another chapter, page, table or figure in this manual
blue text Hyperlink within the document
1., 2., … Steps in a procedure that should be performed in consecutive order
«ER» LEDs of the amplifier (for example, «ER»
< > parameter name
[xx] Pin number of the rear connector
"…" Used for references
Table 3: Identifiers
3.2.4 Safety and liability
NOTICE
The information in this document is subject to change without further notice.
HCS assumes no responsibility for any faults that may appear in this manual.
This operating manual represents the knowledge of HCS and during the drafting of this operating
manual the greatest possible care was taken. Nevertheless, HCS disclaims any responsibility and
liability claims for individual applications of the user. This is particularly true in cases of non-
compliance, omissions, faults, misinterpretations and misunderstandings.
Applicable laws and safety standards have to be observed at any time. Before commissioning or
using the equipment, the necessary risk analysis must be conducted and suitable protection
measures must be taken.
This manual only describes the functionality and influence of the parameters. The described
software functionality can be used in various amplifier models which can be implemented in a
vast range of applications. Hence it is not possible to assume liability for the influence of the
parameters.
HCS GmbH refuses any liability in case of omission to comply with these requirements.
In the case of applications with critical safety requirements or where accident prevention
regulations must be observed, it may be necessary to isolate the components from the solenoids
with relays in e-stop circuits.
To switch off the enable signal (0 V at terminal 8d) is insufficient. In these cases, hydraulic and/or
mechanical safety measures to stop the drive must be provided (e.g. through switching valves
with position monitoring).