DAC-42(A)-x-PN
Page 8
DAC-42(A)-x-PN
Manual
Revision: 1.0
22.01.2024
All types of proportional directional valves, which may be used in all kinds of different
environments and applications, can eventually fail and hence are able to cause damage.
It is the customers obligation to analyze all safety related aspects of the application. It is within
the full responsibility of the machine builder and/or system integrator to make the final selection
of products and reassure and confirm that all requirements regarding safety and performance are
met.
The procedure of selecting the proper control system and related safety levels is covered by the
machine directive EN 13849.
NOTICE
Liability for any content of this document is rejected!
Any claims against HCS GmbH – based on whatever legal reason – resulting from the use of the
information, programs, engineering and performance data etc., described in this document shall
be excluded. Exclusion in such cases shall not apply for mandatory liability, e.g. under the
“Product Liability Act”, in case of intent, gross negligence, or injury of life, body or health,
guarantee for the quality of a product, fraudulent concealment of a deficiency or breach of a
condition. Damages for breach of a substantial contractual obligation are, however, limited to the
foreseeable damage, typical for the type of contract, except in the event of intent or gross
negligence or injury to life, body or health. The above provisions do not imply a change of the
burden of proof to your detriment.
We reserve the right to make changes to this document at any time without prior notice.
3.2.5 General information
ESD (electrostatic discharge) may damage components on the card. In order to prevent any
damage please always follow the recommendations below!
Discharge static voltage from your body by using best practice.
Work in safe environment and do not use any devices in the working surrounding which could
generate or hold static charge. Avoid using the product in areas where floors or surfaces are
composed of materials that could generate static charges.
Handle all equipment very carefully and do not touch exposed pins or components.
Store and transport the units only in its original packaging.
To Next Page
Loading...