Unpacking and Setting up 1
TANGO / TANGO XL – Operation 1–13
■
Remove the transport safeguard bracket
for the drum cover
Undo the transport safeguard for the drum
cover:
1. firstly, screw out the 2 screws using the
Phillips screwdriver
2. raise the cover by 5 - 10 cm, so that you can
reach the other screws better
3. now using a 10 mm wrench, undo the two
screws on the cover.
■
Lifting drum cover
Lift the cover manually by about another
45 cm.
The cover can no longer be
pushed down.
■
Fitting the lid of the unit
Establish the electrical plug-in connections
for the lid (see also
Undoing electrical plug-
in connections
) and then attach it using the
M 6x6 screws from the accessories box.
1
To Next Page
Loading...
