TANGO/TANGO XL
Additional Information (EN)
Order No. 05382351
Edition April 1999
ABC
1/2
Compared with previous version 5.1.4, the following has changed for
the operation of TANGO/TANGO XL in the LinoColor Version 6.0
(the changes made also relate to TANGO/TANGO XL operating in-
structions, Order No.: 05338085):
1. Connecting TANGO/TANGO XL to the operating station:
(page 2 – 4)
You must incorporate an SCSI interface card into your computer if
your Power Macintosh has no SCSI connection. TANGO/TANGO XL
is only connectable using SCSI.
2. Installing LinoColor software: (page 2 – 8)
You need to have installed operating software 8.5 on your Power
Macintosh in order to be able to use LinoColor 6.0.
3. Installing calibration data: (page 2 – 9)
As of LinoColor version 6.0, specific calibration data for your
scanner is in the form of ICC Profiles and is delivered on CD and
no longer on diskette. Keep the CD in a safe place. If you wish to
new ICC-profiles for your new scanner, you must click on ICC-
profiles for TANGO (from ’’TANGO Profiles’’ CD) in the LinoColor
installation window.
4. Replacing scanning drums – TANGO XL only: (page 4 – 4)
When replacing the drum and changing from a large to a small
scanning drum or vice versa. LinoColor automatically switches to
the correct scanner drum display during an overview scan.
However, the scan mode, whether standard or Copix, is
maintained, even if you replace a Copix drum with a standard
drum or vice versa.
The barcode number on the drum is crucial for this automatic
switch-over. Malfunctions in LinoColor may result if the following
number allocation is not adhered to.
tangozettel_us.fm Seite 1 Donnerstag, 11. Mai 2000 3:46 15
To Next Page
Loading...
