HEIDENHAIN TNC 426, TNC 430 257
8.4 Cycles for milling pockets, studs and slots
8.4 Cycles for milling pockets,
studs and slots
Overview
Cycle Soft key
4 POCKET MILLING (rectangular)
Roughing cycle without automatic pre-positioning
212 POCKET FINISHING (rectangular)
Finishing cycle with automatic pre-positioning,
2nd set-up clearance
213 STUD FINISHING (rectangular)
Finishing cycle with automatic pre-positioning,
2nd set-up clearance
5 CIRCULAR POCKET
Roughing cycle without automatic pre-positioning
214 CIRCULAR POCKET FINISHING
Finishing cycle with automatic pre-positioning,
2nd set-up clearance
215 CIRCULAR STUD FINISHING
Finishing cycle with automatic pre-positioning,
2nd set-up clearance
3 SLOT MILLING
Roughing/finishing cycle without automatic pre-
positioning, vertical depth infeed
210 SLOT RECIP. PLNG
Roughing/finishing cycle with automaticpre-
positioning, with reciprocating plunge infeed
211 CIRCULAR SLOT
Roughing/finishing cycle with automaticpre-
positioning, with reciprocating plunge infeed
To Next Page
Loading...
