390 10 Programming: Q Parameters
10.10 Preassigned Q Parameters
Workpiece status Parameter value
Good Q180
Re-work Q181
Scrap Q182
Measured deviation with cycle 440 Parameter value
X axis Q185
Y axis Q186
Z axis Q187
Reserved for internal use Parameter value
Markers for cycles (point patterns) Q197
Status during tool measurement with TT Parameter value
Tool within tolerance Q199 = 0.0
Tool is worn (LTOL/RTOL exceeded) Q199 = 1.0
Tool is broken (LBREAK/RBREAK exceeded) Q199 = 2.0
To Next Page
Loading...
