M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Reset M109/M110
n
n
n
page 185
M114
M115
Automatic compensation of machine geometry when working with tilted axes
Reset M114
n
n
page 193
M116
M117
Feed rate for angular axes in mm/minn
Reset M116
n
n
page 191
M118 Superimpose handwheel positioning during program runn n page 187
M120 Pre-calculate radius-compensated contour (LOOK AHEAD) n page 185
M126
M127
Shorter-path traverse of rotary axes
Reset M126
n
n
page 191
M128
M129
Maintain the position of the tool tip when positioning with tilted axes (TCPM)
Reset M128
n
n
page 194
M130 Moving to position in an untilted coordinate system with a tilted working plane n page 180
M134
M135
Exact stop at nontangential contour transitions when positioning with rotary axes
Reset M134
n
n
page 196
M136
M137
Feed rate F in millimeters per spindle revolution
Reset M136
n
n
page 184
M138 Select tilting axes n page 196
M140 Retraction from the contour in the tool-axis direction n page 188
M141 Suppress touch probe monitoring n page 189
M142 Delete modal program information n page 190
M143 Delete basic rotation n page 190
M144
M145
Compensating the machine’s kinematic configuration for ACTUAL/NOMINAL positions at
end of block
Reset M144
n
n
page 197
M200
M201
M202
M203
M204
Laser cutting: Output programmed voltage directly
Laser cutting: Output voltage as a function of distance
Laser cutting: Output voltage as a function of speed
Laser cutting: Output voltage as a function of time (ramp)
Laser cutting: Output voltage as a function of time (pulse)
n
n
n
n
n
page 198
M Effect Effective at block - start end Page
To Previous Page
Loading...
