HERMOS LFM 4x - Page 86

Customer manual
LFM 4x Reader
RFID
WE GENERATE SOLUTIONS
HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: +49 9279 991 - 0
E-mail: rfid@hermos.com
LFM 4x Reader Rev1.3
back to the table of contents
80
www.hermos.com
„SELF_TEST_RESULT“ Returns the result of the last self-test. A self-test can
be triggered by message S18F13 using SSCMD.
„MANUFACTURER“ String from the manufacturer „HERMOS“
„ECID_00“ bis „ECID_99“ see data element ECV parameters 0 - 99
Head attribute definitions:
„HeadStatus“ Current state
„IDLE“ Reader in REST mode
„BUSY“ reader is busy
„NOOP“ Not in operation
„HeadID“ corresponds to the 2-digit target ID of the first antenna port
„01“ or „00“
Where used S18F2, S18F3
State request value
OpStatus Operating status, maintenance or rest mode
„OP“ ... operating status
„MT“ ... maintenance status
LEDStatus LED-status
„Off“ ... switch off the LED
„On“ ... switch on the LED
„Flash“ ... switch the LED to flashing mode with 1Hz
LedNo LED-number, 1 Byte
„1“ first LED of the Reader Heads (if available)
„2“ second LED of the Reader Heads (if available)
„3“ red status LED of the reader
„4“ green status LED of the reader
Timeout Timeout duration, Units seconds
„00“: permanently
„01“ bis „FF“: Timeout from 1 to 255 s. After the timeout, the LED goes off.
Where used S18F13
The number of LEDs per antenna input depends on the design of the
hardware.
CPVAL Format: A[]