(4) Screws
34
(5) Headlamp connector
(6) Position lamp connector
4
5
3. Remove the screws (4).
4. Pull the headlamp case (2) slightly up,
carefully release the tabs (3) from the
slots.
6
5. Disconnect the headlamp connector
(5), position lamp connector (6) and
remove the headlamp case.
Installation
Headlamp focus is factory preset.
However in case of adjustment required
please follow the steps as given below.
Vertical adjustment
Installation can be done in the reverse
order of removal.
Headlamp focus
(1) Screw (2) Headlamp case (3) Tabs
2
3
1
(1) Bolt (A) Up (B) Down
1
A
B
To Next Page
Loading...
