35
OPERATIONS
PRE-RIDE INSPECTION
For your safety, it is very important to take
a few moments before each ride to walk
around your scooter and check its
condition. If you detect any problem, be
sure you take care of it or have it corrected
by your Authorised Hero MotoCorp
workshop.
Always perform a pre-ride inspection
before every ride and correct if any
problem.
Improper maintenance or failing to
correct a problem before riding can
cause a crash in which you can be
seriously injured.
2. Fuel level - Fill fuel tank when
necessary (page 18). Check for leaks.
1. Engine oil level- Add engine oil if
required (page 53 ). Check for leaks.
9. Steering - check for smooth action for
easy maneuverability.
5. Throttle - Check for smooth opening
and full closing in all steering
positions.
3. Front and Integrated brakes - Check
operation and if necessary, adjust free
play (pages 15 to 17).
7. Rear view mirror - ensure that the rear
view mirror gives a good rear view when
you are sitting on the scooter.
10. Air suction valve - make sure all tube
connections are secured properly (page 68).
6. Lamps and horn - Check that
headlamp, tail/ stop lamp, turn signal
lamps, indicators and horn function
properly.
8. Fitting & fasteners - check & tighten if
necessary.
11. Side stand indicator - make sure that the
side stand is up. If it is in down position
the side stand indicator (page 29) will
glow on the speedometer panel.
4. Tyres - Check condition and pressure
(pages 20).
An improperly adjusted headlamp may
blind oncoming driver or it may fail to
light the road for safe distance.
1. Park the scooter on main stand on a
level ground in front of a wall.
2. Loosen the bolt (1) and move the
headlamp up or down for correct focus.
To Next Page
Loading...
