6. Inflate the tyres to their recommended
pressures. Park the scooter on blocks
to raise both tyres off the ground.
Reinstall the spark plug and spark
plug cap.
4. Remove the battery. Store in an area
protected from freezing temperatures
and direct sunlight. Charge the battery
once a month.
7. Cover the scooter (don't use plastic or
other coated materials) and store in an
unheated area, free of dampness with a
minimum o f daily t e m perature
variation. Do not store the scooter in
direct sunlight.
5. Wash and dry the scooter. Wax all
painted surfaces. Coat chrome plated
parts with rust inhibiting oil.
Crank the engine several times to
distribute the oil.
68
4. Perform all Pre-ride Inspection
checks (page 35). Test ride the scooter
at low speeds in a safe riding area
away from traffic.
3. Drain any excess aerosol rust -
inhibiting oil from the fuel tank. Fill
the fuel tank with fresh petrol.
REMOVAL FROM STORAGE
1. Uncover and clean the scooter.
Change the engine oil if the scooter
has been stored for more than
4 months.
2. Check the battery voltage and charge
the battery as required. Install the
battery.
AIR SUCTION VALVE
Air Suction Valve (1) supplies fresh air
from the air filter to the exhaust manifold
to convert carbon monoxide to carbon
dioxide. This reduces the CO% in the
vehicle's exhaust.
Further to meet emission standards this
scooter is provided with the air suction
valve.
(1) Air Suction Valve
1
To Next Page
Loading...
