HERO XTREME 200S PROGRAMMED FI - Pre-Ride Inspection Checklist; Pre-Ride Component Checks; Engine Starting Procedure; Catalytic Converter Idling Caution

31
Ensure that adequate care should be taken
while cleaning the side stand switch.
CAUTION
!!
Your vehicle is equipped with “Side
stand engine kill” feature for safety
purpose.
This feature has following functions:
•
It prevents starting the engine when
transmission is in gear (irrespective of
clutch lever operation) and side stand is
down.
•
It stops the running engine when
transmission is in gear (irrespective of
clutch lever operation) and side stand is
moved down.
WARNING
!!
“Side stand engine kill” system is not affected
by clutch lever operation.
To inspect the functionality of this feature,
park the vehicle on its main stand and check
all the conditions described in the inspection
flow diagram:
INSPECTION FLOW DIAGRAM
2. Then shift the transmission to gear (with
engine running and irrespective of clutch
lever operation).
Does engine stop?
Visit Authorised
Hero MotoCorp
Workshop
NO
1. Press the electric starter switch (with
transmission in neutral and side stand is
down).
3. Now press the electric starter switch (After
engine has stopped).
NO
SYSTEM IS OK
Does engine start?
YES
Visit Authorised
Hero MotoCorp
Workshop
NO
YES
Does engine start?
Visit Authorised
Hero MotoCorp
Workshop
YES
If your vehicle doesn't operate as described in
above flow diagram, please visit your
Authorised Hero MotoCorp workshop.