33
WARNING
!!
Petrol is extremely flammable and is explosive
under certain conditions. Refill in a well
ventilated area with the engine stopped. Do
not smoke or allow flames or sparks in the
area where the vehicle is refilled or where
petrol is stored.
Location : On the left side of the rear cowl,
above rear wheel.
SEAT LOCK
Operation : Insert the ignition key (1) and
turn it clockwise to unlock the seat. To
install, engage the hook on the underside of
the seat with the frame and slide the seat to
the front until the lock clicks.
(1) Seat lock
1
HELMET HOLDER
The helmet holder is located below the
seat. Remove the seat. Hang the helmet on
the helmet holder hook (1) using wire
helmet set (2) supplied with the vehicle.
Install the seat (3) and lock it securely.
(1) Helmet holder hook (2) Wire helmet set
(3) Seat
WARNING
!!
•
Riding with a helmet attached to the holder
can interfere with the rear wheel of
suspension and could cause a crash in which
you can be seriously hurt of killed.
•
Use the helmet holder only while parked. Do
not ride with a helmet secured by the holder.
3
1 2
You should conduct pre ride inspection before
riding the vehicle to enhance riding comfort
and safety.
PRE- RIDE INSPECTION
Clean your vehicle regularly. It protects the
surface finish. Avoid cleaning with products
that are not specifically designed for vehicle
surfaces.
Inspect your vehicle every day before you start
the engine. The items listed here will only take
a few minutes, and in the long run they can
save time, expense, and possibly your life.
To Next Page
Loading...
