35
Preparation
Before starting insert the key and follow the
below mentioned procedure :
•
Confirm that the programmed FI
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
“OFF” once the engine is started.
•
Turn the ignition switch (1) "ON" position.
(1) Ignition switch
(2) Malfunction indicator lamp (MIL)
2
1
NOTE
If MIL remains “ON” even if the vehicle is
programmed FI system. It is recommended to
started, there is an abnormality in the
reduce the speed and drive to the Authorised
Hero MotoCorp workshop for check-up.
Ÿ Find neutral position & check neutral
N indicator (3) on instrument console
with ignition "ON".
•
Make sure that the engine stop switch/kill
switch (4) is at “ON” ( ) position.
(3) Neutral indicator
3
(4) Engine stop/kill switch
4
• Electric start : Press the electric starter
switch with fully closed throttle.
• Kick start : Depress the kick starter until
resistance is felt. Then let the kick starter
return to the top of its stroke. Kick from the
top of the stroke through to the bottom with
a rapid, continuous motion.
To Next Page
Loading...
