Power supply
•
Before powering on the product, make sure the electrical interfaces are dry and clean. Do NOT power on the product in humid conditions.
•
Do NOT use out-of-spec or damaged cables or adapters.
•
You are recommended to use only the cables and power adapters provided by Hesai. If you are to design, configure, or select the power supply
system (including cables) for the product, make sure to comply with the electrical specifications in the product's user manual (refer to Section
1.4 Specifications and the Power Supply Requirements section if available); for technical support, please contact Hesai.
•
Please check Section 2.2 Electrical interface and strictly follow the instructions on plugging/unplugging the connector. If abnormalities already
exist (such as bent pins, broken cables, and loose screws), stop using the product and contact Hesai technical support.
Eye safety
The product is a Class 1 laser product. It satisfies the requirements of:
•
IEC 60825-1:2014
•
EN 60825-1:2014+A11:2021
•
21 CFR 1040.10 and 1040.11 except for deviations (IEC 60825-1 Ed.3) pursuant to Laser Notice No.56, dated May 8, 2019.
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
CAUTION
•
For maximum self-protection, it is strongly warned that users do NOT look into the transmitting laser through a magnifying product
(microscope, eye loupe, magnifying glass, etc.).
•
This product does not have a power switch. It starts operating once connected to power. During operation, the entire cover lens can be
regarded as the product's laser emitting window; looking at the cover lens can be regarded as looking into transmitting laser.
Pandar64
-6-
To Next Page
Loading...
Need help?
General
