2.2.2. Connector use
Connection 1. Turn off the power source.
2. Align the red dots on the connector shells.
3. Push the plug straight into the socket.
Disconnection 1. Turn off the power source.
2. Pull the release sleeve on the male connector to its outermost position and hold it.
3. Pull the plug from the socket.
•
Before connection, check the pins on the socket and the holes on the plug. In case of bent pins or damaged holes, stop using the
connector and contact technical support.
•
To prevent breakdowns, turn off the power source before connection and disconnection.
•
Do NOT attempt to force open a connection by pulling on the cables or by twisting the connectors in any way. Doing so can loosen the
connectors' shells, or even damage the contacts.
•
If the connector's shell is accidentally pulled off, stop using the connector and contact Hesai technical support.
•
Do NOT attempt to assemble the connector's shell and cable collet; do NOT connect a connector without its shell. Doing so may damage
the lidar's circuits.
•
For further troubleshooting, please contact Hesai's technical support or obtain work instructions from the connector manufacturer.
•
The connector is designed to withstand at least 1000 mating cycles; exceeding this number may increase the risk of connector damage.
Pandar64
-21-
To Next Page
Loading...
Need help?
General
