Hettich EBA 200 - Switching the Centrifuge On and Off

AB1800en_SARev.: 03 / 11.2023
18 / 39
Commissioning
Connecting the centrifuge
Switching the centrifuge on
Switching off the centrifuge
NOTICE
Damage to the device by unauthorised personnel
− Tampering with and modications to devices by unau-
thorised persons are at the operating organisation's own
risk and will result in the loss of all warranty and liability
claims.
NOTICE
Damage to the device due to condensation.
There is a risk of condensation forming on electrical com-
ponents when component surfaces are cold and the sur-
rounding air is warmer. The condensation that forms may
cause a short circuit and/or destroy electronics.
− Warm the device up for at least 3 hours in a warm room
before connecting it to the mains.
or
−
Warm up for 30 minutes in a cold room.
Personnel:
■
Trained user
1. A type B residual current circuit breaker must be used if the device
is additionally protected with a residual current circuit breaker in the
building installation.
When using a different type, the residual current circuit breaker may
either not switch off the unit if there is a fault on the unit, or it may
switch off the unit even though there is no fault on the unit.
2. Check whether the mains voltage matches the specication on the
rating plate.
3. Connect the device to a standard mains socket using the mains
cable.
5.4
Switching the centrifuge on and off.
Personnel:
■
Trained user
Set the mains switch to [I] .
🡆 The buttons ash, depending on the centrifuge type.
The following indicators appear one after the other, depending on
the centrifuge type:
■ the centrifuge model
■ the machine type and program version
■ The last centrifugation data used.
The lid opens.
The rotor is stationary.
Set the mains switch to [0] .