Hettich EBA 200 - Cleaning and Care; Overview Table

31 / 39
Rev.: 03 / 11.2023
AB1800en_SA
Cleaning and care
7.2.7 Indicator backlight
The indicator backlight can be switched off after 2 minutes to save energy.
The rotor is stationary.
1.
Press and hold the [SELECT] button.
🡆 ‘*MACHINE MENU*’ is displayed after 8 seconds.
2.
Press the [SELECT] button repeatedly until ‘-> Settings’ is displayed.
3.
Press the [START/PULSE] button.
🡆 ‘End beep = on’ or ‘End beep = off’ is displayed.
4. Press the [SELECT] button repeatedly until ‘Power save=off’ or
‘Power save=on’ is displayed.
5. Use the [t] buttons to set ‘off’ or ‘on’ .
off: Backlight is switched off.
on: Backlight is switched on.
6. Press the [START/PULSE] button.
🡆
The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7.
Press the [STOP/OPEN] button once to exit the ‘-> Settings’ menu
or
Press the [STOP/OPEN] button twice to exit the ‘*MACHINE MENU*’ .
8
Cleaning and care
8.1
Overview table
Chap. Task to execute
if required
daily
weekly
Annually
Page
8 Cleaning and care     31
8.3 Cleaning     32
8.3 Cleaning the device  X   32
8.3 Cleaning the accessories   X  33
8.4 Disinfection     33
8.4 Disinfecting the device X    33
8.4 Disinfecting the accessories X    33
8.5 Maintenance     34
8.5 Greasing the rubber seal of the centrifuging
chamber
  X  34
8.5 Checking the accessories   X  34