7.2 Machine Menu
7.2.1 Querying system information
The following system information can be queried:
■ Centrifuge model
■
Centrifuge program version
■ Centrifuge type number
■ Date of manufacture of the centrifuge
■
Centrifuge serial number
■
Frequency converter type
■ Program version for the frequency inverter
The rotor is stationary.
1. Press and hold the
[SELECT]
button.
🡆
‘*MACHINE MENU*’
is displayed after 8 seconds.
2. Press the
[SELECT]
button.
‘-> Info’
is displayed.
3. Press the
[START/PULSE]
button.
🡆 The centrifuge model is displayed.
4.
Press the
[SELECT]
button.
🡆 The centrifuge program version
‘CP FW=’
is displayed.
5. Press the
[SELECT]
button.
🡆 The centrifuge type number
‘Type#1:’
is displayed.
6. Press the
[SELECT]
button.
🡆 The continuation of the centrifuge type number
‘Type#2:’
is dis-
played.
7. Press the
[SELECT]
button.
🡆 The date of manufacture
‘Date:’
of the centrifuge is displayed.
8. Press the
[SELECT]
button.
🡆 The centrifuge serial number
‘Serial#:’
is displayed.
9. Press the
[SELECT]
button.
🡆 The type of frequency converter
‘FC type’
of the centrifuge is dis-
played.
10. Press the
[SELECT]
button.
🡆 The program version of the frequency converter
‘FC FW=’
of the
centrifuge is displayed.
11. Press the
[STOP/OPEN]
button twice to exit the
‘-> Info’
menu
or
Press the
[STOP/OPEN]
button three times to exit the
‘*MACHINE
MENU*’
.
7.2.2
Cycle counter
The cycle counter is switched off for the EBA 200 S
because there is no set limit for the rotor's period of use.
To Next Page
