RPM indicator
1. If required: Press the
[RCF]
button.
🡆 The parameter RCF (
‘>RCF<’
) or RPM (
‘RPM’
) is displayed. Press
the
[RCF]
button to toggle between the two parameters.
2. Enter the desired centrifugation parameters.
3. Press and hold the
[START/PULSE]
button.
🡆 The centrifugation run is started.
The timing starts at
‘0:00’
.
The rotor speed or the resulting RCF value and the elapsed time
are displayed during the centrifugation run.
4. Release the
[START/PULSE]
button to end the centrifugation run.
🡆 Ramp-down takes place with the set brake level. The brake level is
displayed.
When the rotor is at a standstill, the lid opens, an audible signal
sounds and the remaining number of run cycles (centrifugation
runs) is displayed.
6.5 Quick stop function
Personnel:
â–
Trained user
Press the
[STOP/OPEN]
button twice.
🡆
Ramp-down with brake level "fast" (shortest ramp-down time) is
displayed and executed.
7
Software operation
7.1
Centrifugation parameters
7.1.1 Input with the SELECT button
The number of centrifugation parameters that can be set
differs depending on whether the RPM indicator or the RCF
indicator is selected.
This chapter describes input of the centrifugation parame-
ters with the RPM indicator and RCF indicator selected,
one after the other.
The display returns to the previous values if no button is
pressed for 8 seconds after parameter selection or during
parameter entry. The parameters must then be entered
again.
1.
If required: Press the
[RCF]
button to select the RPM indicator.
🡆 Press the
[RCF]
button to toggle between the two parameters
RPM (
‘RPM’
) and RCF (
‘>RCF<’
).
2.
Press the
[SELECT]
button.
🡆 Runtime in
‘t/min’
is displayed
To Next Page
Loading...
