Hettich EBA 200 - Automatic Lid Unlocking

AB1800en_SARev.: 03 / 11.2023
30 / 39
Software operation
Switching on and off
7.2.5 Visual signal
The indicator backlight ashes as a visual signal after the centrifugation run
is nished.
1.
Press and hold the [SELECT] button.
🡆 ‘*MACHINE MENU*’ is displayed after 8 seconds.
2.
Press the [SELECT] button repeatedly until ‘-> Settings’ is displayed.
3.
Press the [START/PULSE] button.
🡆 ‘End beep = on’ or ‘End beep = off’ is displayed.
4. Press the [SELECT] button repeatedly until ‘End blinking=off’ or ‘End
blinking =on’ is displayed.
5. Use the [t] buttons to set ‘off’ or ‘on’ .
off: Backlight does not ash.
on: Backlight ashes.
6. Press the [START/PULSE] button.
🡆
The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the [STOP/OPEN] button once to exit the ‘-> Settings’ menu
or
Press the [STOP/OPEN] button twice to exit the ‘*MACHINE MENU*’ .
7.2.6
Automatic unlocking of the lid
Setting whether or not the lid unlocks automatically after the centrifugation
run.
The rotor is stationary.
1. Press and hold the [SELECT] button.
🡆 ‘*MACHINE MENU*’ is displayed after 8 seconds.
2. Press the [SELECT] button repeatedly until ‘-> Settings’ is displayed.
3. Press the [START/PULSE] button.
🡆 ‘End beep = on’ or ‘End beep = off’ is displayed.
4. Press the [SELECT] button repeatedly until ‘Lid AutoOpen=off’ or ‘Lid
AutoOpen=on’ is displayed.
5. Use the [t] buttons to set ‘off’ or ‘on’ .
off: Lid does not unlock automatically.
on: Lid unlocks automatically.
6. Press the [START/PULSE] button.
🡆 The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the [STOP/OPEN] button once to exit the ‘-> Settings’ menu
or
Press the [STOP/OPEN] button twice to exit the ‘*MACHINE MENU*’ .