Hettich EBA 200 - Operation; Opening and Closing the Lid; Rotor Installation and Removal

19 / 39
Rev.: 03 / 11.2023
AB1800en_SA
Operation
Opening the lid
Closing the lid
Removing the rotor of the EBA
200
6 Operation
6.1
Opening and closing the lid
Personnel:
■
Trained user
The centrifuge is switched on.
The rotor is stationary.
Press the [STOP/OPEN] button.
🡆 The lid unlocks by means of a motor.
The ‘Lid unlocked’ indicator appears.
CAUTION
Danger of crushing when closing the lid.
Danger of crushing ngers when the closing motor pulls the
lid against the seal.
− No parts of the body should be in the hazard zone of the
lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
− Close the lid slowly.
−
Do not slam the lid.
Personnel:
■
Trained user
Close the lid and press the front edge of the lid down gently.
🡆
The lid locks using a motor.
The ‘Lid locked’ indicator appears.
6.2
Removing and installing the rotor
The rotor of the EBA 200 S must only be installed and
removed by customer service.
Personnel:
■
Trained user