Hettich EBA 280 - Audible Signal

AB1101en_SARev.: 03 / 11.2023
32 / 44
Software operation
6. Press the [START/PULSE] button.
🡆 The settings are stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the [STOP/OPEN] button once to exit the ‘-> Settings’ menu
or
Press the [STOP/OPEN] button twice to exit the ‘*MACHINE MENU*’ .
7.4.5
Audible signal
7.4.5.1
General
The audible signal sounds:
■
after a problem occurs in the 2s interval.
■ after completion of the centrifugation run and rotor standstill in the 30 s
interval.
Opening the lid or pressing any button stops the audible signal.
7.4.5.2
Setting an audible signal
1.
Press and hold the [SELECT] button.
🡆 ‘*MACHINE MENU*’ is displayed after 8 seconds.
2. Press the [SELECT] button repeatedly until ‘-> Settings’ is displayed.
3. Press the [START/PULSE] button.
🡆 ‘End beep = on’ or ‘End beep = off’ is displayed.
4. Use [Adjustment buttons] to set ‘off’ or ‘on’ .
off: Audible signal after completion of the centrifugation run is disa-
bled.
on: Audible signal after completion of the centrifugation run is ena-
bled.
5. Press the [SELECT] button.
🡆 ‘Error beep = on’ or ‘Error beep = off’ is displayed.
6. Use [Adjustment buttons] to set ‘off’ or ‘on’ .
off: Audible signal after the occurrence of a malfunction is disabled.
on: Audible signal after the occurrence of a malfunction is enabled.
7. Press the [SELECT] button.
🡆 ‘Beep volume = min’ , ‘Beep volume = mid’ or ‘Beep volume =
max’ is displayed.
8. Use [Adjustment buttons] to set ‘min’ , ‘mid’ or ‘max’ .
min: The volume of the audible signal is set to low.
mid: The volume of the audible signal is set to medium.
Max: The volume of the audible signal is set to loud.
9. Press the [START/PULSE] button.
🡆 The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.