Troubleshooting Page 5-6
L000950, Version: 4.0 February 2016
Job Data Error
(PC Error Message No. 106)
The print data sent to the Printer is
corrupt or has been interrupted.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Lam 1 Tag Err
(PC Error Message No. 259)
A RFID read or write error occurred
on Cartridge 1.
Retry, and if it fails again the material
cannot be used.
Lam 2 Tag Err
(PC Error Message No. 260)
A RFID read or write error occurred
on Cartridge 2.
Retry, and if it fails again the material
cannot be used.
Lam Async Error
(PC Error Message No. 245)
The Printer timed out waiting for
communication from the Laminator.
Check Lam power/connections and
restart the Printer.
Lam Card Jam
(PC Error Message No. 53, 212, 214,
and 215)
A jam occurred somewhere between
the Printer and the Laminator.
Open covers and clear the
obstruction/jam.
Lam Check Card
(PC Error Message No. 213)
A jam occurred inside the Laminator.
Open Lam cover and clear the
obstruction.
Lam Com Error
(PC Error Message No. 246)
There was a communication failure
between the Printer and Laminator.
Check Lam power/connections and
restart the Printer.
Lam Error
(PC Error Message No. 237, 238)
A generic unknown error as occurred.
Reset the Printer and try again. If this
problem persists, call for technical
assistance.
Lam Card Not Ejected
(PC Error Message No. 216)
The card is not ejected from the
Laminator.
The Lamination material is stuck to the
card.
Lam Handler Startup Error
(PC Error Message No. 66)
A problem was detected during
Printer start-up.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Lam Handler Startup Error
(PC Error Message No. 141)
After powering up the Printer, the
Laminator was detected, but an error
occurred which would prevent its use.
Check Laminator power and
connections and restart the Printer.
Lam Internal Error
(PC Error Message No. 48)
A generic unknown error as occurred
in the Laminator.
Check Laminator power and
connections and restart the Printer.
Lam No Film
(PC Error Message No. 157)
There is no material loaded in the
Laminator.
Load Laminator material.
Lam Timeout
(PC Error Message No. 247)
The Printer timed out while
processing information related to the
Laminator.
Check Lam power/connections and
restart the Printer.
Lam1 Wrong Film
(PC Error Message No. 233)
Material in Cartridge 1 of the
Laminator does not match the
material type specified by the job.
Make sure Driver material matches
what is actually in the Laminator.
Lam2 Wrong Film
(PC Error Message No. 234)
Material in Cartridge 2 of the
Laminator does not match the
material type specified by the job.
Make sure Driver material matches
what is actually in the Laminator.
Laminate 1 Bad
(PC Error Message No. 259, 261)
The Lamination material in Cartridge 1
is not valid for this Laminator.
Install valid material.
LCD Error Message Cause Solution
To Next Page
Loading...
