Troubleshooting Page 5-8
L000950, Version: 4.0 February 2016
No Flip Module
(PC Error Message No. 201)
Two-sided job sent to a one-sided
Printer.
Verify the Printer has flipper
capabilities through the LCD Menu.
If Flipper capabilities are present,
ensure that the Print Both Sides option
in the Driver is set correctly.
Press Resume on the Printer’s Front
Cover to continue printing.
To cancel the print, press Cancel Print
from the Driver’s display dialog.
No Flip Module
(PC Error Message No. 45, 201)
The desired lamination requires a
Flipper Module.
Change the Cartridge location of the
Lamination material (if it is dual sided),
or buy a Flipper Module.
No iCLASS Encoder
(PC Error Message No. 177)
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
To cancel, click Cancel Print.
No Mag Module
(PC Error Message No. 31)
MAG encoding job sent to Printer
without a MAG Encoder.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
To cancel, click Cancel Print.
No MIFARE Encoder
(PC Error Message No. 203)
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
To cancel, click Cancel Print.
No Prox Encoder
(PC Error Message No. 32)
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
To cancel, click Cancel Print.
No Ribbon
(PC Error Message No. 25)
No Ribbon is installed in the Printer.
OR
The Ribbon RFID tag is bad.
Install the correct Ribbon and press
Resume located o the Printer’s LCD
display.
To cancel the print, press the Cancel
Print button from the Driver's display
dialog and the Cancel button located
on the Printer's LCD display.
No Smart Encoder
(PC Error Message No. 33)
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
To cancel, click Cancel Print.
Printing Error
(PC Error Message No. 107)
An error was detected during
printing.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reboot Required
(PC Error Message No. 9, 65, 67, 163)
Unspecified system error detected by
the Printer Firmware.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reinsert Ribbon
(PC Error Message No. 141)
The Ribbon must be reinserted for
proper functioning of the Printer.
Reinsert the Ribbon or press Resume.
Remove Card
(PC Error Message No. 68)
A card is jammed in the Print Station
or card flipping area of the Printer.
Clear the jam and press Cancel.
LCD Error Message Cause Solution
To Next Page
Loading...
