HID iCLASS SE - Regulatory; Safety - for Indoor Use Only

iCLASS SE Reader Module Hardware Developer’s Guide, SE3200-902, Rev. C.1
Page 49 of 52 February 2014
8 Regulatory
8.1 RoHS
The SE32XX RoHS Declaration is located from the iCLASS SE Reader micro-site.
8.2 REACH
The SE32XX REACH Letter is located from the iCLASS SE Reader micro-site.
8.3 Safety – for Indoor Use Only
The following describes HID iCLASS SE Reader module regulatory guidelines.
• UL Recognition (Recognized Component) to UL294 for the USA and CSA C22.2
No. 205 for Canada. The mark is cRUus where the R is backwards.
• OEM Final Product UL Listing
Because HID OEM Modules are cRUus recognized, UL treats them as a
recognized component and therefore must be evaluated by UL in the final
product for UL Listing.
• Transient surge protection (transorbs) is not provided for the SE32XX module.
• The iCLASS SE Reader module is intended to be part of a reader. The reader in
which the iCLASS SE Reader module is used must translate the 3 VDC module
Voh signaling to 4 to 5.5 VDC Voh SIA AC-01 (1996.10) signaling requirements.
The UL File for the iCLASS SE Reader Module is BP6568, Category Code ALVY2. View
from the public UL Directory at
http://database.ul.com/cgi-
bin/XYV/template/LISEXT/1FRAME/index.htm.
8.4 Product Radio Certifications
The iCLASS SE Reader Module was tested under the FCC and Industry Canada rules
for a Modular Approval and therefore the following shall apply (reference below
FCC/IC ID).
• Provided that the Antenna, Antenna to module cable and tuning network have
not been changed in any way; the final product label may contain the FCC ID,
provided no other radio devices exist within the final assembly.
• The End User/Manufacturer, will not need to repeat the intentional emissions
testing (actual radio certification), however the un-intentional emissions testing
will need to meet the FCC and IC requirements with the module installed into the
final assembly or product. This also applies to CE Marking as defined by the
R&TTE Directive.
• However, in many cases, the module may need to be retuned, due to the affects
of the product enclosure and assemblies within this enclosure, and the de-tuning
affect that this may have on the radio circuitry. In this case and if other radios
exist, C2PC is required.
• In the event that the HID OEM modules Kit is modified in any way, the radio
transmitter operating at either 125 kHz or 13.56 MHz and the module is
integrated into the OEM’s final product, Radio Certification is required for the
final product.