HIKVISION DS-7200-SH Series

User Manual of DS-7200-SH/SV&DS-7300-SH Series DVR
118
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate device over network.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
Figure 9.1 General Network Settings of DS-7200-SH/SV
Figure 9.2 General Network Settings of DS-7300HWI/HFI-SH
2. Select the General tab.
3. In the General Settings interface:
You can configure the following settings: NIC Type, IPv4 Address, IPv4 Gateway, MTU and DNS
Server.
Note: The DS-7200-SH/SV models provide one 10M/100Mbps self-adaptive network interface, and the
DS-7300HWI/HFI-SH models provide one 10M/100M/1000Mbps self-adaptive network interface.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP
address and other network settings from that server.
Note: The valid value range of MTU is 500 ~ 1500.
4. After having configured the general settings, click the Apply button to save the settings.