EasyManuals Logo

HIKVISION DS-7200-SH Series User Manual

HIKVISION DS-7200-SH Series
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
User Manual of DS-7200-SH/SV&DS-7300-SH Series DVR
47
5.1 Configuring Encoding Parameters
Purpose:
By configuring the encoding parameters you can define the transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
Figure 5.1 HDD- General
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota, please set the maximum record capacity and maximum picture
capacity. For detailed information, see Chapter 10.5 Configuring Quota Mode.
3) If the HDD mode is Group, you should set the HDD group. For detailed information, see Chapter
5.9 Configuring HDD Group for Recording.
Figure 5.2 HDD- Advanced
Steps:
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-7200-SH Series and is the answer not in the manual?

HIKVISION DS-7200-SH Series Specifications

General IconGeneral
BrandHIKVISION
ModelDS-7200-SH Series
CategoryDVR
LanguageEnglish

Related product manuals