User Manual of DS-7200-SH/SV&DS-7300-SH Series DVR
55
5) To schedule an all-day recording, check the checkbox after the All Day item.
Figure 5.17 Edit Schedule- All Day
6) To arrange other schedule, leave the All Day checkbox blank and set the Start/End time.
Note: Up to 8 periods can be configured for each day. And the time periods can’t be overlapped
each other.
Repeat the above steps3)-6) to schedule motion detection triggered recording for all the week. If
the schedule can also be set to other days, click Copy.
Figure 5.18 Copy Schedule to Other Days
7) Click OK to back to upper level menu.
If you can to copy the same schedule settings to other camera (s), click Copy to enter the Copy Camera
interface, and then select the camera (s) you want to copy.
Figure 5.19 Copy Schedule to Other Channels
5.4 Configuring Alarm Triggered Record
Note: This section is available for DS-7300HWI/HFI-SH models only.
Purpose:
Follow the procedure to configure alarm triggered recording or capture.
To Next Page
Loading...
Need help?
General