To Next Page

To Previous Page

User Manual of DS-7200-SH/SV&DS-7300-SH Series DVR

123

4. Configure the following NTP settings:

• Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.

• NTP Server: IP address of NTP server.

• NTP Port: Port of NTP server.

5. Click the Apply button to save and exit the interface.

Note: The time synchronization interval can be set from 1 to 10080min, and the default value is 60min. If the

device is connected to a public network, you should use a NTP server that has a time synchronization function,

such as the server at the National Time Center (IP Address: 210.72.145.44). If the device is setup in a more

customized network, NTP software can be used to establish a NTP server used for time synchronization.

9.2.4 Configuring SNMP

Purpose:

You can use SNMP protocol to get device status and parameters related information.

Steps:

1. Enter the Network Settings interface.

Menu > Configuration > Network

2. Select the SNMP tab to enter the SNMP Settings interface.

Figure 9.14 SNMP Settings Interface

3. Check the SNMP checkbox to enable this feature.

4. Configure the SNMP settings.

Figure 9.15 Configure SNMP Settings

5. Click the Apply button to save and exit the interface.

Note: Before setting the SNMP, please download the SNMP software and manage to receive the device

information via SNMP port. By setting the Trap Address, the device is allowed to send the alarm event and

exception message to the surveillance center.

HIKVISION DS-7200-SH Series User Manual

Questions and Answers: