HIKVISION DS-K1T341C Series

If the interval between card swiping of the same card is less than the set value, the card
swiping is invalid. You can set it as 0 to 255.
Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Card Reader Type/Card Reader Descripon
Get card reader type and descripon. They are read-only.
Fingerprint Capacity
View the maximum number of available
ngerprints.
Exisng Fingerprint Number
View the number of existed ngerprints in the device.
Advanced
Enable Card Reader
Enable the funcon and e device can be used as an card reader.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of main board according to the
card reader parameters. Generally, adopts the default sengs.
Max. Interval When Entering PWD
When you inpung the password on the card reader, if the interval between pressing two
digits is larger than the set value, the digits you pressed before will be cleared
automacally.
Tampering Detecon
Enable the an-tamper detecon for the card reader.
Max. Times of Card Failure
Set the max. failure aempts of reading card.
Fingerprint Recognion Level
Select the ngerprint recognion level in the drop-down list.
Face 1:N Mathcing Threshold
Set the matching security level when authencang via 1:N matching mode. The larger the
value, the smaller the false accept rate and the larger the false
rejecon rate when
authencaon.
Face Recognion Interval
The me interval between two connuous face recognions when authencang. By
default, it is 2s.
Face
An-spoong
Enable or disable the face an-spoong funcon. If enabling the funcon, the device can
recognize whether the person is a live one or not.
DS-K1T341C Series Face Recognion Terminal User Manual
161