The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Super Password
The specic person can open the door by inpung the super password.
Note
●
The duress code and the super code should be dierent.
●
The duress code and the super password should be dierent from the authencaon
password.
●
The length of duress code and the super password is according the device, usually it should
contains 4 to 8 digits.
5.
Click OK.
6.
Oponal: Click Copy to , and then select the door to copy the parameters in the page to the
selected doors.
Note
The door's status duraon sengs will be copied to the selected door(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
Steps
1.
Click Access Control → Advanced Funcon → Device Parameter .
2.
In the device list on the le, click to expand the door, select a card reader and you can edit the
card reader's parameters on the right.
3.
Edit the card reader basic parameters in the Basic
Informaon page.
Note
●
The displayed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Basic Informaon
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
DS-K1T341C Series Face Recognion Terminal User Manual
160