HIKVISION DS-K3G501X-R-M-DM55 - 1 Overview; 1.1 Introduction; 1.2 Main Features; 2 System Wiring

1 Overview
1.1 Introducon
The tripod turnsle is designed to detect unauthorized entrance
or exit. By
adopng the turnsle integratedly with the access
control system, person should authencate to pass through the
lane via swiping IC or ID card, scanning QR code, etc. It is widely
used in
aracons, stadiums, construcon sites, residences, etc.
1.2 Main Features
●
Bidireconal (Entering/Exing) lane.
●
Support remote control and management by HCP soware.
●
High-brightness LED indicates the entrance/exit and passing
status.
●
Fire alarm passing: When triggered, the arms will be dropped
automacally for emergency evacuaon.
●
Support PC web browser, easy to do the conguraon.
●
Support ISAPI protocol for 3rd party
integraon development.
2 System Wiring
The preparaon before installaon and general wiring.
Steps
1. Draw a central line on the
installaon surface of the le or
right pedestal.
2. Draw other parallel lines for installing the other pedestals.
Note
The distance between the nearest two line is 782 mm.
3. Slot on the installaon surface and dig installaon holes
according to the hole
posion. Put 4 expansion bolts for each
pedestal.
4. Bury cables. Each lane buries 1 high and 1 low voltage cable.
For details, see the system wiring diagram below.
1