HIKVISION DS-K3G501X-R-M-DM55 - Configure Parameters for Door;Elevator

Note
●
The displayed parameters may vary for dierent access
control devices.
●
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
Enable NFC
If enable the
funcon, the device can recognize the NFC
card. You can present NFC card on the device.
Enable M1 Card
If enable the
funcon, the device can recognize the M1 card.
You can present M1 card on the device.
Enable EM Card
If enable the funcon, the device can recognize the EM card.
You can present EM card on the device.
4. Click OK.
5.
Oponal: Click Copy to, and then select the access control
device(s) to copy the parameters in the page to the selected
device(s).
Congure Parameters for Door/Elevator
Aer adding the access control device, you can congure its
access point (door or
oor) parameters.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced
Funcon → Device
Parameter .
2. Select an access control device on the le panel, and then click
to show the doors or oors of the selected device.
3. Select a door or oor to show its parameters on the right page.
4. Edit the door or oor parameters.
Note
●
The displayed parameters may vary for dierent access
control devices.
●
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
Name
Edit the card reader name as desired.
Exit Buon Type
You can set the exit buon as remaining closed or remaining
open. Usually, it is remaining open.
Open Duraon
The door contact can be enabled with appropriate delay
aer person with extended access needs swipes her/his
card.
5. Click OK.
6. Oponal: Click Copy to , and then select the door/oor(s) to
copy the parameters in the page to the selected
doors/oor(s).
49