HIKVISION DS-K3G501X-R-M-DM55 - 7.1 Configuration Flow of Client Software; 7.2 Device Management; 7.2.1 Add Device; Add Device by IP Address or Domain Name

7.1 Conguraon Flow of Client Soware
Follow the ow diagram below to congure on the client
soware.
Figure 7-1 Flow Diagram of Conguraon on Client Soware
7.2 Device Management
The client supports managing access control devices and video
intercom devices.
Example
You can control entrance & exit and manage aendance aer
adding access control devices to the client; you can perform video
intercom with the indoor
staons and door staons.
7.2.1 Add Device
The client provides three device adding modes including by IP/
domain and IP segment. The client also supports
imporng
mulple devices in a batch when there are large amount of
devices to be added.
Add Device by IP Address or Domain Name
If you know the IP address or domain name of the device to add,
you can add devices to the client by specifying the IP address (or
domain name), user name, password, etc.
Steps
1. Enter Device Management module.
2. Click Device tab on the top of the right panel.
The added devices are displayed on the right panel.
3. Click Add to open the Add window, and then select IP/Domain
as the adding mode.
4. Enter the required
informaon.
Name
Create a descripve name for the device. For example, you
can use a nickname that can show the locaon or feature of
the device.
Address
The IP address or domain name of the device.
Port
33