HIKVISION DS-K3G501X-R-M-DM55 - Set Door Parameters

Figure 6-7 Set Authencaon Parameters
Click Save to save the
sengs aer the conguraon.
Terminal
Choose Entrance or Exit for sengs.
Terminal Type/Terminal Model
Get terminal descripon. They are read-only.
Enable Authencaon Device
Enable the authencaon funcon.
Authencaon
Select an authencaon mode according to your actual needs
from the drop-down list.
Authencaon Interval
You can set the authencaon interval of the same person
when
authencang. The same person can only authencate
once in the congured interval. A second authencaon will be
failed.
Alarm of Max. Failed
Aempts
Enable to report alarm when the card reading aempts reach
the set value.
Max. Authencaon Failed Aempts
Enable to report alarm when the card reading aempts reach
the set value.
Communicaon with Controller Every
When the access control device cannot connect with the card
reader for longer than the set me, the card reader will turn
oine automacally.
Note
The authencaon interval value ranges from 2 s to 255 s.
Set Door Parameters
Click Conguraon → Access Control → Door Parameters .
Click Save to save the sengs aer the conguraon.
Door No.
Select Entrance or Exit for sengs.
Door Name
You can create a name for the door.
Open Duraon
23