HIKVISION DS-K3G501X-R-M-DM55 - 6.6.12 Card Settings; Set Card Security; Set Card No. Authentication Parameters; 6.6.13 Set Privacy Parameters

7. Click Save.
6.6.12 Card Sengs
Set Card Security
Click Conguraon → Card Sengs → Card Type to enter the
sengs page.
Set the parameters and click Save.
Enable NFC Card
Reserved.
Enable M1 Card
Enable M1 card and authencang by presenng M1 card is
available.
M1 Card
Encrypon
Sector
M1 card encrypon can improve the security level of
authencaon.
Enable the funcon and set the encrypon sector. By default,
Sector 13 is encrypted. It is recommended to encrypt sector
13.
Enable EM Card
Enable EM card and
authencang by presenng EM card is
available.
Note
If the peripheral card reader supports presenng EM card, the
funcon is also supported to enable/disable the EM card
funcon.
Enable DESFire Card
The device can read the data from DESFire card when enabling
the DESFire card funcon.
DESFire Card Read Content
Aer enable the DESFire card content reading funcon, the
device can read the DESFire card content.
Enable FeliCa Card
The device can read the data from FeliCa card when enabling
the FeliCa card
funcon.
Set Card No. Authencaon Parameters
Set the card reading content when authencate via card on the
device.
Go to Conguraon → Card Sengs → Card No. Auth. Sengs .
Select a card authencaon mode and enable reversed card No.
at your actual needs. Click Save.
6.6.13 Set Privacy Parameters
Set the event storage type.
Go to Conguraon → Security → Privacy Sengs
The event storage type is overwring by default. The earliest 5%
events will be deleted when the system detects the stored events
has been over 95% of the full space.
6.6.14 Set Fingerprint Parameters
28