HIKVISION DS-KD8003-IME2 - Page 27

Before You Start
Figure 4-9 Gang Box
Note
The dimension of two-module gang box is: 237 (W) × 134 (H) × 56
(D) mm. The dimension is for reference only.
Steps
1. Drill the installaon hole, and pull the cable out.
Note
●
The suggested dimension of installaon hole is 220 (H) × 108
(W) × 33 (D) mm.
●
The suggested length of cables le outside is 270 mm.
Figure 4-10 Drill the Installaon Hole
2. Select a cable entry and remove the plasc sheet.
3. Mark the gang box screw holes on the hole.
1) Routs the cables through the gang box hole.
2) Insert the gang box into the installaon hole.
3) Mark the gang box screw holes' posion with a marker, and
take out the gang box.
17