HIKVISION DS-KD8003-IME2 - Access Control Settings

Click Number Sengs to enter the page.
Figure 6-23 Number Sengs
Click Add, set the Room No. and SIP numbers in the pop-up
dialog box.
6.4.9 Access Control Sengs
Door Parameters
Set the parameters of the door which is linked to the device.
Steps
1. Click Access Control → Door Parameters to enter the sengs
page.
Figure 6-24 Door Parameters
2. Select Door No., and edit the Name.
3. Set Open Duraon. When the me to open over the open
duraon you set, the door will be locked again.
4. Select Relay Reverse as ON or Disable.
5. Click Save to enable the sengs.
Elevator Control
Before You Start
Make sure that the door staon is in the mode of main door
staon. Only the main door staon supports elevator control
funcon.
Steps
1. Click Access Control → Elevator Control Parameter to enter
the
sengs page.
53