HIKVISION DS-KD8003-IME2 - Page 49

Maintenance
Click Maintenance → Upgrade & Maintenance to enter the
sengs page.
Figure 6-4 Maintenance
●
Reboot: Click Reboot to reboot the device.
●
Default
Click Default to restore all parameters to default
sengs.
Restore All
Click Restore All to reset all the parameters, except the IP
parameters and user
informaon, to the default sengs.
●
Export parameters:
1. Select Device Parameters, and click Export to pop up the
dialog box.
2. Set and
conrm the encrypon password.
3. Click OK to export parameters.
●
Import
Cong. File:
1. Click browse icon to select the conguraon le.
2. Click Import and enter the encrypon password to import.
●
Upgrade:
1. Click browse icon to select the upgrade le.
2. Click Upgrade.
Note
○
The upgrading process will last 1 to 10 minutes, do not
power o during the upgrading. The device reboots
automacally aer upgrading.
○
You can select controller, display module and sub modules
to upgrade.
Authencaon
Click Security → Authencaon to enter the sengs page. On
the page, you can select RTSP
Authencaonaccording to your
actual needs.
Click Save to enable the sengs.
Security Service
Click Security → Security Service to enter the sengs page. On
the page, you can enable SSH according to your actual needs.
Click Save to enable the sengs.
User Management
39