HIKVISION DS-KD8003-IME2 - Page 69

Follow the instrucons below to congure the system sengs,
include System Sengs, Maintenance, Security, and User
Management, etc.
Click System to enter the
sengs page.
Basic Informaon
Click System Sengs → Basic Informaon to enter the sengs
page. On the page, you can edit Device Name and Device No. Set
the Language and System Type according to your needs.
Click Save to enable the sengs.
Time Sengs
Click System Sengs → Time Sengs to enter the sengs page.
Select the Time Zone of your locaon from the drop-down list.
●
Enable NTP, set the Server Address, NTP Port and Interval.
●
Enable Manual Time Sync., set the me manually or check the
Sync. with computer me.
Click Save to enable the sengs.
DST
Click System Sengs → DST to check Enable DST. Set the
parameters according to your needs and click Save to enable the
sengs.
About
Click System Sengs → About to enter the page. Click View
Licenses to view open source soware Licenses.
Maintenance
Click Maintenance → Upgrade & Maintenance to enter the
sengs page.
Figure 7-4 Maintenance
●
Reboot: Click Reboot to reboot the device.
●
Default
Click Default to restore all parameters to default sengs.
Restore All
Click Restore All to reset all the parameters, except the IP
parameters and user informaon, to the default sengs.
●
Export parameters:
59